Products / Anti-Yellowing Series

Thermal Stability & Anti-Yellowing Catalysts

This is the differentiated part of the range. PC-42 holds colour below 100°C for long dwell times, while PC-50 and PC-51 remain stable above 150°C and can lift the heat resistance of the whole compound — methyl silicone toward phenyl performance, phenyl toward fluoro. These grades are specified into PPF top coats, optical films and high-temperature moulded parts.

Specification

Grades in this family.

ModelPt concentrationAppearance / viscosityRecommended dosageStatus
PC-425,000 PPMColorless, transparent, 300–500 cP0.05%–0.5% of total compoundAvailable
PC-50Custom (1,000–20,000 PPM)Colorless, transparent, 5–50 cP0.05%–0.5% of total compoundAvailable
PC-51Custom (1,000–20,000 PPM)Colorless, transparent, 5–50 cP0.05%–0.5% of total compoundAvailable

Add 0.05%–0.5% of total compound mass as a starting point; adjust against line speed, section thickness and inhibitor dosage. Do not allow direct contact with hydrogen-containing silicone oil or pure inhibitor before mixing. Shake before use.

Inhibitor pairing

Complete the curing system.

The catalyst sets the cure speed; the inhibitor sets how long the batch stays workable. Low-yellowing grades are usually paired with medium-high temperature inhibitors; PC-612 is preferred where a full week of pot life is required.

Recommended module

Recommended to use with PC-611 / PC-612 Silicone Inhibitors for precise curing control.

Not sure about the ratio? Send your cure temperature and target bath life — we will return a starting dosage for both components.

How do I know which Anti-Yellowing Series grade fits my line?

Start from the concentration band your current formulation uses, then confirm cure speed and colour against a sample. If you do not have a current reference, send your line speed, cure temperature and section thickness for a recommendation.

Can I get a custom concentration in this family?

Yes. Concentrations from 1,000 to 20,000 PPM are supplied to order; the batch COA states the measured platinum content.

What documentation is supplied?

A TDS per grade, an SDS in the requested language, a batch COA and a RoHS/REACH compliance statement on request.

Next step

Request a sample or get a quote

Tell us the grade, target PPM and application. Our technical team replies within 24 hours with a recommended grade and sample lead time.

Technical reply within 24 hours
Evaluation samples in 5–7 days
COA, TDS and SDS on request
Custom concentration 1,000–20,000 PPM